![]() ![]() Many Kwikset models require pushing the button one time after the button is released, which automatically starts the handling process. Release the button when the lock beeps and the LED flashes red. Keep Holding for About 30 SecondsĬontinue holding the program button for 30 seconds after the battery tray is installed. Some trays have arrows that will remind you which way they went in. Letting go of the button will disrupt the reset process, and you will have to start over. While still holding the program button, reinsert the batteries. Reinsert the Batteries With the Button Still Held Have the battery tray faced correctly and ready to be installed with your free hand. You will need to keep holding this button for the next few steps. It is not hard to locate and should be the only black button somewhere close to the center. Once the batteries are removed, press and hold the main program button. Remember how you pulled them out, as they will need to go back in the same way during step five. Once you have removed the tray, take a moment to ensure that the batteries are correctly installed and seated. Remove the whole tray, which is the rectangular portion visible at the top. Most Kwikset smart locks come with a battery tray that can be found at the top of the lock, holding four AA batteries. To ensure that the screws do not get misplaced, it is advisable to set them aside in a secure place. There are usually only a few screws, and they are located on the bottom. Otherwise, you'll have to locate the panel cover screws and remove them. This requires removing the cover of the inner section of the lock.ĭepending on the model, you may be able to pull the cover straight up and off. To initiate the reset process, you must have access to two components-the batteries and the program button located on the inside of the lock. Set something in front of the door to ensure it doesn't close before you finish all the steps. This will help avoid any issues like it staying locked if there is an error in the process. The first step is to start with the door unlocked and open. The whole reset should only take a few minutes, and here are the 7 detailed steps on how to do it. A reset will disconnect the lock from apps and require you to set them up from scratch.You should change both the user and programming codes after resetting for safety.The programming and user codes will be deleted, and it will be set to the default, User (0-0-0-0), Programming (1-2-3-4).Check your model number, as not all Kwikset locks are reset the exact same way. ![]() Factory resetting Kwikset locks deletes all stored data.Performing a factory reset should be considered a last resort, but it may be necessary to resolve certain issues. Here is what you need to be sure you understand before factory resetting your Kwikset smart lock: * Indicates those that will need the manual handing process at step 7.ĭon't see your model on this list? See below for instructions for resetting more popular Kwikset locks. The above process will factory reset the following Kwikset smart lock models: Start the Handing Process: Pressing the program button once will initiate the handing process(*Some Require Manual Handing). ![]() Keep Holding for About 30 Seconds: Release when a flashing red LED indicates the process is completed.Reinsert the Batteries With the Button Still Held: Replace the batteries with your other hand.Begin Holding the Program Button Down: This will be held for about 30 seconds.Remove the Batteries: Take out the battery tray temporarily. ![]()
0 Comments
Leave a Reply. |